Trouble Shooting Guide - PowerWasher RN2600 Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

PRESSURE WASHER
1.
Drain all water from high pres-
sure hose, coil it, and store it
in cradle of the pressure washer
handle.
2.
Drain all water from spray gun
and wand by holding spray gun in
a vertical position with nozzle end
pointing down and squeezing trig-
ger. Store in gun holder.
3.
Store chemical hose so it is pro-
tected from damage.

TROUBLE SHOOTING GUIDE

PROBLEM
Engine will
No fuel.
not start (see
Pressure builds up after two
Engine Manual
pulls on the recoil starter or
for further
after initial use.
engine
Choke lever in the "No Choke"
troubleshoot-
position.
ing)
Spark plug wire not attached.
Engine switch in OFF
position.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
No or low
Spray wand not in high pres-
pressure
sure.
(initial use)
Low water supply.
Leak at high pressure hose
fitting.
Nozzle obstructed.
Water filter screen clogged.
AWSC = Authorized Warranty Service Center
CAUSE
Add Fuel.
Squeeze gun trigger to relieve
pressure.
Move choke to the "Choke"
position.
Attach spark plug wire.
Place engine switch in on posi-
tion.
Move choke to the "No Choke"
position.
See How to Use Spray Wand
instructions in the Operation
Section.
Water supply must be at least
5 GPM @ 20 psi.
Repair leak. Apply sealant tape
if necessary.
See Nozzle Cleaning instruc-
tions in the Maintenance sec-
tion.
Remove and clean filter.
16- ENG
CORRECTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents