Table of Contents
Advertisement
EXTENSION CORDS
Use only extension cords that are intended for outdoor
use. These extension cords are identified by a marking
"Acceptable for use with outdoor appliances: store indoors
while not in use". Use only extension cords having an
electrical rating not less than the rating of the product.
Do not use damaged extension cords.
Examine extension cord before using and replace if
damaged.
Do not abuse extension cord and do not pull on any cord
to disconnect.
Keep cord away from heat and sharp edges. Always
disconnect the product from the extension cord.
When using an extension cord, observe the specifi-
cation below:
Cable Length
Up to 25 ft.
WARNING: To reduce the risk of
electrocution, keep all connections dry
and off the ground. Do not touch plug
WARNING
with wet hands.
A. Inspect cord before using. Do not use
if cord is damaged
B. Keep all connections dry and off the
ground.
WARNING
C. Do not touch plug with wet hands.
GROUND-FAULT CIRCUIT-INTERRUPTER PRO-
TECTION
A. Connect to only a properly grounded GFCI
circuit.
B. This pressure washer is provided with a ground-
fault circuit-interrupter (GFCI) built into the plug
of the power-supply cord. This device provides
additional protection from the risk of electric shock.
Should replacement of the plug or cord become
necessary , use only identical replacement parts
that include GFCI protection.
English
WARNING
5.1
1. Make sure water supply is connected and turned
2. Make sure the unit is plugged in.
3. Release gun safety if locked. (Fig. 17) Shown on
4. Remove any dirt or foreign matter from the gun
Wire Gauge
12 AWG Outdoor
5. Insert the wand into the gun's quick connect cou-
6. To allow air to escape from the hose, squeeze
NOTE: Make sure wand is locked.
WARNING
7. Press power switch on the pressure washer to the
8. Squeeze the gun trigger to start the pressure
WARNING
NOTE: Make sure wand is locked. (see fig.13) As
5.2
The variable spray nozzle can adjust spray from fan
to pencil point. The spray is adjusted by turning the
nozzle. (Fig.19-20) See page 14.
13
5.0
OPERATING INSTRUCTIONS
WARNING: Risk of Injury. Do not
direct discharge stream at anyone.
START-UP PROCEDURE
on.
page 11.
outlet and the male connector of the wand.
pling by pushing firmly and twisting wand ¼ of a
turn to lock into place. (Fig. 13) Shown on page
10.
trigger on the gun until there is a steady stream of
water coming from the nozzle.
WARNING: If the wand is not securely
locked into place, it could be ejected
under high pressure when operating
the gun.
"ON" position. (Fig.18) As shown on page 14.
washer.
WARNING: Make sure the wand is
pointed in a safe direction when starting
the pressure washer. Do not point at face
or feet as serious injury could result.
shown on page 10.
VARIABLE SPRAY NOZZLE
Hide quick links:
Advertisement
Table of Contents
