1
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar
4
Bolt (1/2 x 3-3/4 inches)
4
Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of
the machine, using 4 bolts (1/2 x 3-3/4 inches) and
four flange-nuts (1/2 inch) (Figure 3)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 100 to 110 ft-lb (136 to 149
N-m).
1
2
3
g014601
Figure 3
3. Flange-nut (1/2 inch)
2
Installing the Seat
Parts needed for this procedure:
1
Seat
1
Seat wire harness
Procedure
Note: Mount the seat in the front set of mounting
holes to gain an additional 3 inches (7.6 cm) in the
forward adjustment, or in the rear mounting holes for an
additional 3 inches (7.6 cm) in the rearward adjustment.
1. Remove and discard the lag bolts securing the seat
slides and cut the shipping straps.
2. Remove the 4 bolts (5/16 x 3/4 inch) and washers
from the shipping bracket and discard the bracket.
3. Secure the seat to the seat base with 4 bolts and
washers removed previously (Figure 4).
5
1
2
3
4
1. Seat
2. Seat base
3. Washer
13
g016317
Figure 4
4. Bolt (5/16 x 3/4 inch)
5. Install the seat using these
holes.