Toro 04530 Operator's Manual page 22

Figure 23
1. Reel speed control
Seat Adjusting Lever
The seat adjusting lever is located on the front, right
corner of the seat (Figure 24), allowing you to adjust the
seat fore and aft. Push the lever to the left (towards the
center), to release the lock and slide the seat.
Note: If you need additional adjustment on the seat,
you can remove the four bolts securing the seat to the
base and move the seat to the second set of mounting
holes provided.
1
Figure 24
1. Seat adjusting lever
Note: Before lifting the seat, slide it to the furthest
back position and move the steering arm fully forward.
Fuel Shut-Off Valve
Close the fuel shut-off valve (Figure 25), behind the seat
and under the fuel tank, when storing or transporting
the machine on a truck or trailer.
1. Fuel shut-off (under the fuel tank)
Cutting Unit Power Disconnect
Couplers
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power
supply by separating the cutting unit power disconnect
couplers (Figure 26), located as the base of the rollover
bar on the left side of the traction unit. Connect the
couplers together before operating the machine.
g014628
1. Cutting unit power disconnect couplers
22
1
g01462 6
Figure 25
Figure 26