Toro 04530 Operator's Manual page 29

Figure 33
1. Suspension-arm bar
5. Close the latches down and around the cutting-unit
bar and lock them in place (Figure 32).
Note: A "click" can be heard and felt when the
latches are properly locked in place.
6. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 34).
7. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull
the motor retaining bar on the cutting unit toward
the motor until you hear an audible "click" from
both sides of the motor (Figure 34).
2. Cutting-unit bar
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on the
suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 22).
Removing the Cutting Units
1. Disconnect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 22).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally start
the cutting unit, causing serious injury to hands
and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Park the machine on a clean level surface, lower the
cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and
set the parking brake.
3. Push the motor retaining bar out of the slots on
the motor towards the cutting unit and remove the
motor from the cutting unit.
29
Figure 34
3. Cavity
4. Motor retaining bar