Lubricating The Caster And Wheel Bearings; Greasing The Transmission Couplers; Greasing The Mower Belt Idler - Toro 30696 Operator's Manual

2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
1. Lubricate the front wheel bearings and front spindles
(Figure 21).
2. Lubricate the drive wheel bearings (Figure 21).
Greasing the Transmission
Couplers
Lubricate the transmission couplers and idler arm pivots
located in the back of the machine (Figure 22).
Figure 21
Figure 22

Greasing the Mower Belt Idler

Grease the fitting on the mower belt idler arm pivot
(Figure 23).
Note: Remove the mower deck cover to access the
grease fitting for the mower belt idler arm.
26
Figure 23