How To Grease; Lubricating The Caster And Wheel Bearings; Greasing The Mower Belt Idler; Greasing The Pump Control And Bell Crank - Toro 30069 Operator's Manual

How to Grease

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
Service Interval: Before each use or daily
Lubricate the front wheel bearings and front spindles
(Figure 20).

Greasing the Mower Belt Idler

Service Interval: Every 50 hours
Grease the fitting on the mower belt idler arm pivot
(Figure 20).
Note: Remove the mower deck cover to access the
grease fitting for the mower belt idler arm.
Greasing the Pump Control
and Bell Crank
Service Interval: Every 50 hours—Grease the pump
drive idler pivot.
Every 50 hours—Grease the pump
control.
Every 100 hours—Grease the blade
engagement bellcrank.
Every 400 hours—Lubricate the cam
lock with Never-Seez
Grease the fitting on the pump drive idler pivot and the
pump control.
Grease the blade engagement (PTO) bellcrank
(Figure 20).
Lubricate cam lock with Never-Seez
lubricant.
Note: Remove the guards fitted under the machine to
access the grease fitting on the pump drive idler pivot.
® .
®
or equivalent
23
Figure 20
1. Pump drive idler arm
2. Pump control arm
3. Bellcrank
4. Mower belt idler arm
5. Caster wheel bearing
6. Caster pivot