Lubrication; Lubricating The Machine; Lubricating The Caster And Wheel Bearings; Greasing The Transmission Couplers - Toro 30672 Operator's Manual

Lubrication

Grease Type: #2 lithium or molybdenum grease

Lubricating the Machine

1. Disengage the PTO and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag. Make sure
to scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump
grease into the fittings until grease begins to
ooze out of the bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
1. Lubricate the front-wheel bearings and front
spindles (Figure
2. Lubricate the drive-wheel bearings
Figure 22
22).
(Figure
Greasing the Transmission
Couplers
Lubricate the transmission couplers and idler arm
pivots located in the back of the machine
Greasing the Mower Belt
Idler
Grease the fitting on the mower belt-idler arm pivot
(Figure 24).
22).
Note:
Remove the mower-deck cover to access the
grease fitting for the mower belt-idler arm.
g001457
26
(Figure
Figure 23
Figure 24
23).
g001458
g001459