Lubrication; Lubricating The Machine; Lubricating The Caster And Wheel Bearings; Greasing The Transmission Couplers - Toro 30632 Operator's Manual

Lubrication

Grease Type: #2 general-purpose lithium-based or
molybdenum-based grease

Lubricating the Machine

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Clean the grease fittings with a rag. Make sure to scrape
any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of the
bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
1. Lubricate the front wheel bearings and front spindles
(Figure 20).
2. Lubricate the drive wheel bearings.
Figure 20
Greasing the Transmission
Couplers
Lubricate the transmission couplers and idler arm pivots
located in the back of the machine (Figure 21).

Greasing the Mower Belt Idler

Grease the fitting on the mower belt-idler arm pivot (Figure
22).
Note: Remove the mower deck cover to access the grease
fitting for the mower belt-idler arm.
32-inch and 36-inch mower deck
48-inch mower deck
23
Figure 21
Figure 22
Figure 23