Lubrication; Greasing The Bearings And Bushings - Toro 30343 Operator's Manual

Lubrication

Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings
and bushings daily when conditions
are dusty and dirty.)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. Bearings and bushings must be lubricated daily
when operating conditions are extremely dusty and
dirty. Dusty and dirty operating conditions could cause
dirt to get into the bearings and bushings, resulting in
accelerated wear. Lubricate grease fitting immediately
after every washing, regardless of interval specified.
Apply a liberal coating of grease to the check valve pins
once each year (Figure 27). Also grease the bearings in
the rear axle every 500 hours, or yearly, whichever comes
first (not shown). The bearing and bushing lubrication
points are:
• PTO universal shaft (Figure 30)
Figure 30
• Lift arm pivot bushings (Figure 31)
Figure 31
• Brake pivot bushings (Figure 32)
• Brake cables (drive wheel and brake pedal ends)
(Figure 33)
• PTO tension pivot (Figure 33)
• Rear PTO bearing (Figure 33)
• Transmission neutral shaft (Figure 34)
34
Figure 32
Figure 33
Figure 34