Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 30343 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions and Weights (approx.)
Width (measured from outside
of front tires)
Length (without cutter deck)
Height (with ROPS raised)
Dry Weight (without cutter
deck)

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
47 inches (120 cm)
83.5 inches (212 cm)
77 inches (196 cm)
1555 lb (705 kg)
23

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions
and symbols in the safety section. Knowing this
information could help you or bystanders avoid injury.
The use of protective equipment, such as but not
limited to, for eyes, ears, feet, and head is recommended.
This machine produces sound levels in excess
of 85dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.

Checking the Engine Oil

Service Interval: Before each use or daily—Check the
engine oil.
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
the engine is first started.
Crankcase capacity is approximately 3.2 quarts (3 l)
with the filter.
Use high-quality engine oil that meets the following
specifications:
API Classification Level Required: SJ, SK, SL or higher.
Preferred oil: SAE 10W–30 (all temperatures)
Alternate oil: SAE 5W–30 (all temperatures) SAE 30
(above 32 F)
Toro Premium Engine oil is available from your
distributor in 10W–30 viscosity. See the parts catalog
for part numbers.
1. Park the machine on a level surface, lower the
cutting deck, stop the engine and remove the key
from the ignition switch. Open the hood.
2. Remove the dipstick (Figure 20), wipe it clean and
reinstall the dipstick. Remove the dipstick and
check the oil level. The oil level should be up to the
FULL mark on the dipstick