Setup; Installing The Steering Wheel - Toro 30343 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Certificate of Quality
Ignition Key
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: Use this chart as a checklist to ensure that
all parts necessary for assembly have been received.
Without these parts, total set-up cannot be completed.
Some parts may have already been assembled at the
factory.
Description
Steering wheel
Cover
Handle
Screws
No parts required
Seat Belt
Bolt
Lockwasher
Flatwasher
Manual Tube & Cap
R-clamp
No parts required
Electrolyte (not included)
No parts required
Rear weight(s) (not included)
No parts required
Qty.
1
1
1
2
–
2
2
2
2
1
2
–
A/R
–
A/R
–
Qty.
1
1
1
1
1
1
PTO universal shaft is attached to machine
frame. DO NOT ENGAGE PTO without first
removing universal shaft or coupling it to a
suitable implement.
12
Use
Install the steering wheel.
Install the handle to the hood.
Install the seat.
Mount the seat belt.
Install the manual tube on the left
underside of the seat.
Adjust the ROPS.
Activate and charge the battery.
Check the tire pressure.
Install the rear weight.
Adjust Counterbalance Pressure
Use