Table of Contents
Advertisement
2. Remove the 2 nuts and vinyl caps (if previously
installed) securing the upper seat bracket to the left
side of the seat suspension (Figure 7).
1. R-clamps
2. Upper seat bracket
3. Seat suspension
3. Loosely mount the R–clamps to the seat bracket
studs with the 2 nuts previously removed (Figure 7).
The R–clamps are to be positioned under the seat
suspension tabs.
4. Install the manual tube into the R–clamps and
tighten the nuts (Figure 7).
5. Insert the vinyl caps onto the seat bracket studs.
6
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the two
pins (Figure 8).
Figure 7
4. Manual tube
5. Vinyl cap
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 8).
Note: Lower roll bar slowly so damage to hood does
not occur.
7
Activating and Charging the
Battery
Parts needed for this procedure:
A/R
Electrolyte (not included)
Procedure
Use only electrolyte (1.265 Specific Gravity) to fill
battery initially.
1. Remove the battery from the machine.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent
caps (Figure 9).
15
Figure 8
3. Hairpin cotter pin
Advertisement
Table of Contents
