Fuel System Maintenance; Inspecting Fuel Lines And Connections; Replacing The Fuel Filter; Electrical System Maintenance - Toro 07359 Operator's Manual

Hide thumbs Also See for 07359:
Table of Contents

Advertisement

Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever comes
first)
Inspect the fuel lines, fittings, and clamps for signs of leaking,
deterioration, damage, or loose connections.
Note: Repair any damaged or leaking fuel system component
before using the machine.

Replacing the Fuel Filter

Service Interval: Every 800 hours/Yearly (whichever comes
first)
1. Raise the box and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Unscrew the fuel filter from the bracket
Figure 37
1. Fuel filter
4. Install the replacement filter by turning it until the
filter contacts the top of the bracket, then tighten it an
additional 3/4 of a turn.
(Figure
37).
1
G017504
Electrical System
Maintenance

Servicing the Battery

Battery voltage: 12 volt with 540 cold cranking amps at -18°
C (0° F).
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
DANGER
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
• Do not drink electrolyte or allow it to contact
your skin, eyes or clothing. Wear safety glasses
to shield your eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.
Always keep the battery clean and fully charged.
Always keep the battery clean and fully charged.
If the battery terminals are corroded, clean them with a
solution of 4 parts water and 1 part baking soda.
Apply a light coating of grease to the battery terminals
to prevent corrosion.
Disconnecting the Battery
WARNING
Incorrect battery cable routing could damage the
vehicle and cables, causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always reconnect the positive (red) battery cable
before reconnecting the negative (black) cable.
• Always keep the battery strap in place to protect
and secure the battery.
33
WARNING

Advertisement

Table of Contents
loading

This manual is also suitable for:

07359tcWorkman mdx-d

Table of Contents