Table of Contents
Advertisement
6. Remove any remaining debris using a fast-drying
contact cleaner or brake cleaner.
Note: Remove the debris in and around moving parts.
7. If debris or buildup exists around the belt or along the
clutch shaft, use a fine abrasive pad or a similar product
to remove it.
8. Install the spring, clutch cover, and flange-head bolts.
9. Torque the bolts to 12-13.5 N-m (105-120 in-lb).
Cooling System
Maintenance
Cleaning the Engine Cooling
Areas
Service Interval: Every 100 hours
Clean the external surfaces of the engine every 100 operating
hours or more often under extremely dusty and dirty
conditions.
Important: Never clean the engine with pressurized
water because water could contaminate the fuel system.
Filling the Radiator
Initial Fill/Filling after Flushing
Service Interval: Every 1,000 hours/Every 2 years
(whichever comes first)
Note: Use a 50/50 mix of Ethylene Glycol and water for
coolant.
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
CAUTION
If the engine has been running, the
pressurized, hot coolant can escape and cause
burns.
• Do not open the radiator cap when the
engine is running.
• Allow engine to cool at least 15 minutes
or until the radiator cap is cool enough to
touch without burning your hand.
• Use a rag when opening the radiator cap,
and open the cap slowly to allow steam to
escape.
2. Remove the fill cap
1
1. Fill cap
41
(Figure
52) and fill with coolant.
2
G016859
Figure 52
2. Radiator overflow tank cap
Advertisement
Table of Contents
