Maintenance; Recommended Maintenance Schedule(S) - Toro 07359 Operator's Manual

Maintenance

Note: Looking for an Electrical Schematic or Hydraulic Schematic for your machine? Download a free copy of the schematic by
visiting www.Toro.com and searching for your machine from the Manuals link on the home page.
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
After the first 100 hours
Before each use or daily
Every 100 hours
Every 150 hours
Every 200 hours
Every 300 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Yearly
Important: Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the condition of the drive belt.
• Change the engine oil.
• Perform the breaking in a new machine guidelines.
• Preform the pre-staring checks. Check the following items each time you begin
using the machine for the day:
• Check the brake-fluid level.
• Check the engine oil. Check the oil level in the engine before the engine is first
started.
• Check the tire pressure.
• Check gear shift operation.
• Inspect the primary drive clutch.
• Check the radiator coolant level.
• Grease the bearings and bushings.
• Air-cleaner filter: Inspect after every 100 operating hours Replace the air filter
element sooner if it dirty or damaged.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Check the front wheel toe-in and camber.
• Check the transaxle oil level.
• Check the operation of the Neutral gear shift position.
• Clean the engine cooling areas (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions).
• Inspect the brakes.
• Change the engine oil (twice as often in special operating conditions; refer to
Maintaining the Vehicle under Special Operating Conditions).
• Change the oil filter. Change the oil twice as often during special operating
conditions; refer to Maintaining the Vehicle under Special Operating Conditions.
• Replace the air filter element.
• Clean the primary drive clutch (more often in dusty or muddy conditions).
• Adjust the parking brake if needed.
• Check the condition and tension of the drive belt.
• Grease the front wheel bearings.
• Inspect the fuel lines and connections.
• Replace the fuel filter.
• Change the transaxle fluid.
• Change the radiator coolant.
• Change the brake fluid.
• Complete all yearly maintenance procedures specified in the engine owner's manual.
24