Advertisement
Fitting the lid (Cover it VC-S is an optional accessory)
The holes for lid hinges are pre-drilled on the back side of the unit. Each hinge is screwed with 2 screws
(supplied with the lid).
Fit the lid carefully over the hinge prongs and adjust the screws until the lid stays open where you want it to
without being too stiff to open or close.
Technical specifications Vinyl Cleaner VC-S
Nominal speed
Power consumption
Dimensions (W x D x H)
Weight
Fuse 230V/120V
Potential incorrect use and fault conditions
Pro-Ject products are manufactured to the highest standards and undergo strict quality controls before
leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but
can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common
fault symptoms is included.
The platter doesn't turn although the unit is switched on:
The unit is not connected to the mains power supply.
No mains at the socket.
Broken fuse in the main switch.
Overheating protection is active.
Ball knob is not well-tightened.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Guarantee repairs will only be affected if the unit is returned correctly packaged. For this reason we recommend
keeping the original packaging.
Never return a record cleaning machine without making sure that is it safely disassembled and correctly
packaged in the original packaging.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use and/or by transportation without the original packaging. Modification or change to any part
of the product by unauthorized persons, release the manufacturer from any liability over and above
the lawful rights of the customer.
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
©
Copyright
2015. All rights reserved.
6
© Pro-Ject Audio Systems · VC-S · Revision 2015.12.21
30 r.p.m.
230V/800W, 120V/1300W
435 x 335 x 280 mm (fully assembled)
10,5kg (netto)
T5A/T6A
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Advertisement
