System Setup Options - THOMSON ROC8209 Operating Instruction

Pressing OK at SYSTEM SETUP accesses the System Setup Options for Volume Punch-Through control Setup, Time
Setup, Date Setup, Backlight Setup and System Reset.
This remote allows you to select which Mode controls your Volume/Mute keys. The remote is initially set (factory
default) for all Modes programmed with "Visual" codes (e.g. TV, VCR, DVD, PVR, SAT & CABLE) and "Audio"
codes (e.g. CD & AUDIO) to use their own Volume/Mute control if present. If the programmed "Visual" code has
no Volume/Mute operation of its own then those keys will punch-through control to the TV Mode device without
needing to change to TV Mode
Any Mode chosen for Volume/Mute control MUST have its own Volume/Mute function either in the programmed
code or learned otherwise the Volume/Mute keys will do nothing.
This routine will set all Modes to punch-through to any one chosen Mode for Volume/Mute key control without the
needing to change to that Mode.
a. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
b. Release Setup key.
c. Navigate to SYSTEM SETUP. Press and release Okay key. VOL/MUTE SETUP is displayed.
d. Press and release Okay key. VOL/MUTE. ALLE is displayed.
e. Press and release the Okay key. WELCHER MOD.? is displayed.
f. Press and release desired Mode key (TV, VCR, DVD, etc.) for Volume/Mute control.
g. WARTEN will be displayed briefly followed by FERTIG and the remote will exit Setup and return to normal
operation.
h. All Modes will now punch-through to your chosen Mode for Volume/Mute control.
If the chosen Mode has no Volume/Mute commands of its own, FEHLER will
be shown in the display and the remote will exit Setup and return to normal
operation.
This routine will set any Mode to use only its own Volume/Mute control i.e. Volume/Mute punch-through is disabled
for this Mode. Note before using this routine to check the chosen Mode has its own Volume/Mute functions, either
in the code or by learning, otherwise the Volume/Mute keys will do nothing.
a. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
b. Release Setup key.
c. Navigate to SYSTEM SETUP. Press and release Okay key. VOL/MUTE SETUP is displayed.
d. Press and release Okay key. VOL/MUTE. ALLE is displayed.
e. Navigate to MODE/MUTE EINZ. Press and release the Okay key. MODE VOL MODE? is displayed.
f. Press and release desired Mode key (TV, VCR, DVD, etc.) to be disabled for Volume/Mute punch-through
control.
g. WARTEN... will be displayed briefly followed by FERTIG and the remote will exit Setup and return to normal
operation.
h. The chosen Mode will now use its own Volume/Mute control.

System Setup Options

"All Vol. Set" - Setting ALL Volume/Mute Control
to any one Mode e.g. TV
"Mode Vol. Set" - Setting any Mode
to use its own Volume/Mute Control
13