Code Identification - THOMSON ROC8209 Operating Instruction

Facility to manually search specific Brands within the Code Library for a particular manufacturer.
a. Turn on the device to be controlled.
b. Press and hold Setup key until CODE SETUP is displayed (takes approximately 2–3 seconds).
c. Release Setup key.
d. Press and release Okay key. CODELISTE AUFR. is displayed.
e. Navigate to " HERSTEL.-CODES ". Press and release the Okay key. QUELLENTASTE is displayed.
f. Press and release desired Mode key (TV, VCR, DVD, etc.). GERAET? TV is displayed.
g. Using the Up/Down keys, select the Device type to be programmed (TV, VCR, DVD, etc. – see GERAET?
note above). Note - For TV Mode, only TV "Device" can be selected. Press and release the Okay key to confirm
selection.
Brand Key? is now displayed. Press and release the numeric key (0–6) corresponding to desired Manufacturer:
1. Philips
2. Sony, Panasonic, JVC, Toshiba
3. Thomson
4. Telefunken
5. Grundig
6. Nokia
0. Alle anderen Marken für diese Gerätegruppe).
h. FUNKTION TEST is displayed. Press the Program Up key, Power or Play (VCR only) repeatedly until the Device
to be controlled changes channel, turns off or responds accordingly. SUCHEN will be displayed (along with
the Device selection) during the search process. If the required Code is accidentally passed then press the
Channel Down key to backtrack through the Library. Press Channel Up (or Power or Play) to change direction
forward again. Press and release Okay key to install the Code.
i. FERTIG will be displayed and the remote will exit Setup and return to normal operation.
Press the respective Mode key in normal operation to display programmed
code for that Mode e.g. DVD CODE 0768.
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc) will require you to set up two different Mode keys
to control both parts of the Combo device. For example, if you have a TV/DVD Combo, you might need to set up
one code under the TV key to control the TV part AND a separate code (under any other Mode key) to control the
DVD part.
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc) have separate keys on the original remote to select
the part of the Combo device to be controlled. For example, if your Combo device is a DVD/VCR then its original
remote may have separate DVD and VCR keys for selection of the Combo part you would control. The equivalent
key functions can be found on your remote by using the Mode and Setup keys. Assuming the DVD/VCR Combo
device is the example and its code is programmed under DVD Mode, press and hold the DVD Mode key for
more than one second to send the DVD key command. To send the VCR key command, quickly press and release
the Setup key followed by pressing and releasing the DVD Mode key. This method can be applied similarly to
all Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc) and is available for all Modes. This feature is not
supported by all codes.
Programming by search for Brand names

Code Identification

Combo Devices
Programming Combo Device Codes
Controlling Combo Devices
12