Auto Power-Off Function - Vox Dynamic Looper Owner's Manual

Auto Power-Off function

The Dynamic Looper has an Auto Power-Off function that
automatically turns off the power when four hours have
elapsed since the most recent or user input.
Note: Even if an there hasn't been any user input, the Auto
Power-Off function will not engage if there is audio input
present at the input jack.
Note: When the Dynamic Looper is shipped from the
factory, the Auto Power-Off function is enabled.
Disabling the Auto Power-Off
function
Here's how to disable the Auto Power-Off function.
1. Turn the Dynamic Looper's power off.
2. While holding down the STOP MODE button and the
CANCEL button, turn the power on.
The program/value display will indicate "diS," and then
the Dynamic Looper will start up in the normal way.
Enabling the Auto Power-Off function
Here's how to re-enable the Auto Power-Off function after
you've disabled it.
1. Turn the Dynamic Looper's power off.
2. While holding down the STOP MODE button and the
WRITE button, turn the power on.
The program/value display will indicate "EnA," and then
Auto Power-Off function
the Dynamic Looper will start up in the normal way.
Note: The enabled/disabled state of the Auto Power-Off
function is remembered even when you turn off the
power.
41