Vox Dynamic Looper Owner's Manual page 30

VOX Dynamic Looper Owner's manual
Πod: MODULATION
This models a modulation effect.
• EDIT knob: Selects the effect type.
Ch1: Models an analog chorus.
Ch2: This contains two chorus units, producing a complex
modulation effect.
FLA: This models an analog flanger.
PHA: This models an analog phaser.
trE: This models the tremolo circuit built into a guitar
amp.
• PRE FX button + EDIT button: Adjusts the modulation
speed.
• Control pedal: Controls the depth of the effect.
bAS: BASS
This simulates a bass guitar.
• EDIT knob: Selects the type of sound.
Eb1: A standard electric bass.
Eb2: An electric bass with a compressor applied.
Eb3: An electric bass with overdrive applied.
Eb4: An electric bass with distortion applied.
Sb1: A synth bass.
Sb2: A variation of the synth bass.
• Control pedal: Controls the output level.
30
Aco: ACOUSTIC
This simulates an acoustic guitar.
• EDIT knob: Selects the type of sound.
S-1: An old, small-bodied acoustic guitar, suitable for
delicate arpeggios.
S-2: A small-bodied acoustic guitar with a distinctive
mid-range, loved by country bluesmen.
Lrg: A large-bodied acoustic guitar with a distinctively
refined sound that's suitable for pop.
rES: A resonator guitar suitable for playing with a slide.
• PRE FX button + EDIT button: Adjusts the depth of the
effect.
• Control pedal: Controls the output level.
Ptc: PITCH
This is a pitch shifter that lets you use the control pedal to
control the pitch.
• EDIT knob: Adjusts the amount of pitch in semitone steps.
-12–0, dtn: Detune, 1–12
• PRE FX button + Adjusts the mix balance between the
direct sound and effect sound.
• Control pedal: Controls the pitch.