Using The Metronome As A Guide While You Record - Vox Dynamic Looper Owner's Manual

VOX Dynamic Looper Owner's manual
If you want to listen to the metronome as a guide while
you record, press the METRONOME button to turn on
the metronome, and then press the TRIGGER/TAP pedal
several times to set the tempo. If you've set the tempo,
the length of the created phrase will be a precise
multiple of the tempo.
) p.20 "Using the metronome as a guide while you record"
) p.20 "Creating phrases of a precise length
(Loop Quantize)"
5. When you've played to the spot where you want to loop
the phrase, press the REC/PLAY/OVERDUB pedal to
stop recording.
Recording for Loop 1 will end, and will switch to loop
playback.
6. Press the STOP pedal to stop playback.
This completes recording for Loop 1.
Using the metronome as a guide while you
record
You can use the metronome as a guide while you record a
loop. Adjust the following settings before you start
recording.
1. Press the TRIGGER/TAP pedal several times to specify
the tempo.
When you press the pedal several times, the tempo will be
set to the interval between your presses.
The METRONOME button will blink at the tempo you
specified.
20
2. Press the METRONOME button.
The metronome will sound at the tempo you specified.
Note: Pressing the METRONOME button will not cause
the metronome to sound unless you have already used the
TRIGGER/TAP pedal to specify the tempo.
3. To adjust the volume of the metronome, hold down the
METRONOME button and turn the EDIT knob.
Specifying the metronome's time signature
Here's how to change the metronome's time signature. With
the factory settings, this is set to 1 (1/4).
1. Hold down the METRONOME button for approximately
two seconds.
The program/value display will indicate "bar," and will
then indicate the time signature setting.
2. Use the EDIT knob to specify the time signature.
The range of time signatures is from 1 (1/4) to 32 (32/4).
You can't change the denominator of the time signature.
3. Press the CANCEL button.
You can't change the time signature or tempo after
recording.
Creating phrases of a precise length
(Loop Quantize)
If you use the TRIGGER/TAP pedal to specify the tempo
before recording, the Loop Quantize function will be
enabled.