Resample A Phrase With The Loop Effect Applied - Vox Dynamic Looper Owner's Manual

Resample a phrase with the Loop Effect
applied
Please refer to "Resampling" on page 25.
Overdubbing a performance
by playing along with a
recorded phrase
Here we'll explain how to overdub by playing along with
the phrase you recorded on Loop 1.
1. Select the program that provides the sound that you
want. As desired, you can also adjust the effect
parameters.
) p.18 "Applying an effect to your guitar performance or
mic audio"
) p.37 "Editing a program"
2. Press the STOP pedal and PROGRAM UP pedal
simultaneously, making the Loop 1 current loop LED
light-up.
3. Press the REC/PLAY/OVERDUB pedal to play back Loop
1.
4. At the point where you want to start overdubbing, press
the REC/PLAY/OVERDUB pedal, and play your
instrument.
The Loop 1 LOOP STATUS LED will light-up orange, and
overdubbing will begin.
Overdubbing a performance by playing along with a recorded phrase
Hint: If a parameter of the Pre Effect is assigned to the
control pedal (the pedal LED will be lit-up red), you can
use the pedal to control the Pre Effect while you overdub.
5. Press the PLAY/REC/OVERDUB pedal at the point
where you want to stop overdubbing.
The Loop 1 LOOP STATUS LED will light-up green, and the
Dynamic Looper will switch from overdubbing to playback.
6. Press the STOP pedal to stop Loop 1 playback.
Hint: The Dynamic Looper lets you specify what will
occur when you stop playback.
) p.25 "Specifying how the loop will stop"
Undoing overdubbing
If you want to cancel the last-performed overdub, proceed as
follows from the overdubbed state.
1. Hold down the PROGRAM UP pedal.
2. When the program/value display blinks "Und," release
the PROGRAM UP pedal.
The last-performed overdub will be undone.
23