Advertisement
FUNCTIONAL DESCRIPTION
Installing
or
removing battery cartridge
*Always switch off the tool before inser-
tion or removal of the battery cartridge.
To remove the battery cartridge, withdraw
it from the tool while sliding the button on
the side
of
the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into
place. Always insert it all the way until it
locks in place with a little click. If you can
see the red part on the upper side of the
button, it is not locked completely. Insert
it
fully until the red part cannot be seen. If
not,
it
may accidentally fall out of the tool, causing injury to you or someone around you.
Do not use force when inserting the batterv cartridqe. If the cartridQe does not slide in
easily, it is not being inserted correctly
Charging
*Plug the battery charger into the proper
AC voltage source. Two charging lights
will flash in green color repeatedly.
Insert the battery cartridge into charger
until it stops adjusting to the guide of
charger. Terminal cover of charger can be
opened with inserting and closed with
pulling out the battery cartridge.
When the battery cartridge is inserted, the
charging light color will change from
green to red and charging will begin. The
charging light will keep lighting up lit
steadily during charging.
One red charging light indicates charged condition in 0 - 80% and two red ones indicates
With finish of charge, the charging lights will change from two red ones to two green
80
-
100%.
ones.
The charging time is as follows:
Battery BH1220: approx.
30
minutes.
Battery BH1233: approx. 50 minutes.
If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last
approximately 24 hours.
*After charging, unplug the charger from the power source.
7
Advertisement
