D-Link DXS-1210 Series User Manual page 90

4 Configuration
D-Link DXS-1210 Series User Manual
Figure 4.140 – ACL > ACL Configuration Wizard – Create IPv6 ACL-Protocol ID
Source: Select the source information. The values are Any, Host and IP.
Destination: Select the destination information. The values are Any, Host and IP.
DSCP (0-63): Enter the DSCP value. And the range is between 0 and 63.
Flow Label (0-1048575): Enter the flow label value. This value must be between 0 and 1048575.
Action: Select the action for the rule. The values are Permit and Deny.
After selecting the ESP option as the Protocol Type then click the associated tabs with IPv6 Address, IPv6
DSCP and Flow Label, the following page will appear:
Figure 4.141 – ACL > ACL Configuration Wizard – Create IPv6 ACL-ESP
Source: Select the source information. The values are Any, Host and IP.
Destination: Select the destination information. The values are Any, Host and IP.
DSCP (0-63): Enter the DSCP value. And the range is between 0 and 63.
Flow Label (0-1048575): Enter the flow label value. This value must be between 0 and 1048575.
Time Range: Enter the time range.
Action: Select the action for the rule. The values are Permit and Deny.
After selecting the PCP option as the Protocol Type then click the associated tabs with IPv6 Address, IPv6
DSCP and Flow Label, the following page will appear:
84