D-Link DXS-1210 Series User Manual page 76

4 Configuration
D-Link DXS-1210 Series User Manual
Ethernet Type (0x600-0xFFFF): Enter the Ethernet type hexadecimal value. The value is between 0x600
and 0xFFFF. When any Ethernet type profile is selected in the Specify Ethernet Type drop-down list, the
appropriate hexadecimal value will automatically be entered.
Ethernet Type Mask (0x0-0xFFFF): Enter the Ethernet type mask hexadecimal value. The value is between
0x0 and 0xFFFF. When any Ethernet type profile is selected in the Specify Ethernet Type drop-down list,
the appropriate hexadecimal value will automatically be entered.
CoS: Select the CoS value used. This value is between 0 and 7.
VID (1-4094): Enter the VLAN ID that will be associated with this ACL rule. The value should be between 1
and 4094.
Time Range: Enter the time range.
Action: Select the action that this rule will take. The values are Permit and Deny.
Click the Back button to return to the previous window.
Click the Next button to continue.
To define the IPv4 ACL: Select IPv4 and then click the Next button. Click the associated tabs with IPv4
Address, Port, IPv4 DSCP and TCP Flag, the following page will appear:
Figure 4.122 – ACL > ACL Configuration Wizard – Create IPv4 ACL
Sequence No. (1-65535): Select and enter the ACL rule number. This value must be between 1 and 65535.
Select Auto Assign to automatically generate an ACL rule number for this entry.
Protocol Type: Select the protocol type option. Options to choose from are TCP, UDP, ICMP, EIGRP, ESP,
GRE, IGMP, OSPF, PIM, VRRP, IP-in-IP, PCP, Protocol ID, and None.
After selecting the TCP option as the Protocol Type then Click the associated tabs with IPv4 Address, Port,
IPv4 DSCP and TCP Flag, the following page will appear:
70