External Temperature Sensor - Webasto Air Top Evo 40 Installation Instructions Manual

Make sure that the installation location satisfies the requirements.
X X
Make sure that the hot air duct satisfies the requirements.
X X
Make sure the cold air inlet, hot air outlet as well as the cold
X X
and hot air ducting are installed in the correct position.
Drill holes.
X X
Secure cold and hot air ducts at all connections.
X X
Fig. 08: Cold air inlet with mesh guard
Installing heater in casing:
X X
– Provide a cross section area of at least 50 cm
inlet.
– Seal off the hot air outlet such that no hot air can enter the
casing.
4.4

External temperature sensor

For fresh air mode, an external temperature sensor must be ins-
talled in the area to be heated.
Installation location requirements:
The installation location must satisfy the following requirements:
■ The installation location is at mid-level of the area to be heated.
■ The installation location is outside the hot air flow.
■ The installation location is outside the range of other heat sour-
ces (e.g. vehicle heating system).
■ The installation location is not in direct sunlight (e.g. not on the
dashboard).
■ The air can circulate unhindered (e.g. not covered by curtains).
Air Top Evo 40 | Air Top Evo 55
2
for the cold air
11