Attaching The Paper Side Stops; Attaching The Chip Bag; Electrical Instructions - Lassco Spinnit FMM-2 User Manual

3 - Setting Up Your Machine

3.5 - Attaching the Paper Side Stops

3.5.1
Attach the Paper Side Stops (FM4-4006) using two (2) Side Stop
Screws (FM4-4007) each. Position the Paper Side Stop as de-
sired and tighten down with light pressure.

3.6 - Attaching the Chip Bag

3.6.1
Attach the Chip Bag (FMM6-652A) to the machine by stretching
the mouth of the bag over the Master Chip Chute and hooking
the aluminum bar onto the bracket located on the top flat portion
of the master chip chute as shown. Please note that you must
empty this bag as needed to avoid clogging.

3.7 - Electrical Instructions

3.7.1
Your FMM-2 comes with an electrical cord containing the plug to
fit into a standard grounded 115V outlet. This machine has a full
load draw of 11 Amps.
3.7.2
Making sure that nothing is interfering with the drill bits, plug the
cord set into a grounded 115V outlet. To turn the machine on,
press the Rocker Switch on the front of the shroud.
Side Stop Screws
Paper Side Stop
Table
Master Chip Chute
Chip Bag
Rocker Switch
Power Cord
Diagram 3-30
Diagram 3-50
Diagram 3-60
Page 07