Table of Contents
Advertisement
4 - Operation
4.4 - Adjusting the Table Height
4.4.1
After you level the drill bits you may need to adjust your table
height. Test drill through a stack of scrap approximately the same
height as that you will be drilling. If the drill bits drill into the Drill
Strip or if the drill bits fail to penetrate through the bottom sheet of
scrap you will need to adjust the table height. If you are using the
card stock under your scrap (recommended) then you should just
be lightly scoring the card stock when the table is in its full upright
position. If your bits are drilling correctly move onto section 4.4.
4.4.2
If your drill bits fail to penetrate through the scrap: Loosen the
Lock Knob of the Vertical Stop Adjustment Assembly and rotate
the large knob counterclockwise allowing the table to travel high-
er. Tighten down the Lock Knob when it is positioned correctly.
4.4.3
If you are drilling into the Drill Strip: Loosen the Lock Knob of
the Vertical Stop Adjustment Assembly and rotate the large knob
clockwise allowing the table to travel lower. Tighten down the
Lock Knob when it is positioned correctly.
4.5 - Adjusting the Back-Gauge Assembly
4.5.1
Adjust the Back-gauge so that it is the correct distance from the
edge of the product to the center of the hole to be drilled by per-
forming the following:
4.5.2
Loosen the Clamp Knob on the right side of the Back-gauge.
4.5.3
Using the two (2) Scales embedded in the rear corners of the
table, align the front edge of the Back-gauge with the desired dis-
tance.
4.5.4
Zero (0) on these scales align with the center of the hollow drill
bits.
4.5.5
Tighten down the Clamp Knob when the Back-gauge
is positioned as desired.
Back Gauge Scale
Drill Strip
Hollow Drill Bits
Back Gauge Scale
Back Gauge
Table
Drill Strip
Diagram 4-80
Table
Lock Knob
Vertical Stop
Adjustment
Foot Treadle
Internal Side View
Diagram 4-90
Clamp Knob
Back Gauge Scale
Page 10
Advertisement
Table of Contents
