Table of Contents
Advertisement
4 - Operation
4.6 - Adjusting the Distance Between Heads
4.6.1
To adjust the spindles to a desired spacing, loosen the Hand
Wheel Lock Knob. Turn the Hand Wheel to move the spindle
farther away from the center or to move the spindle closer to the
center. Please note that the direction you turn the Hand Wheel
depends on the side of the machine. Use the Back-gauge Scale
as a guide. When the spindle is at its desired location tighten the
Hand Wheel Lock Knob by turning clockwise. Repeat with the
second spindle.
4.6.2
When drilling fewer than two (2) holes simply remove undesired
drill bits.
4.7 - Adjusting the Stop Collars
4.7.1
The stop collars, located on the Stop Rod at the left rear of the
Table, are used to either create a stationary table mode of opera-
tion or a traversing mode. Your machine comes set up in station-
ary mode.
4.7.2
For traversing table operations follow steps 4.7.3 through 4.7.5.
Refer to diagram 4-110.
4.7.3
Install the shorter Set Screws included with the machine into the
Stop Collars. Make sure all the Stop Collars are installed with the
shorter Set Screws keeping them loose enough to allow the Stop
Collars to slide into the desired positions.
4.7.4
Set the Stop Collars using the method explained in section 4.8.
4.7.5
When the Collars are positioned as desired, tighten down the
short Set Screws locking them in place using the provided Hex
Wrench (HEX-332).
4.7.6
For stationary table operations follow steps 4.7.7 through 4.7.9.
Refer to diagram 4-120.
4.7.7
Align the table so that zero (0) on the Back-gauge is aligned with
the center drill bit.
4.7.8
Install two longer Set Screws included with the machine into the
adjacent Stop Collars.
4.7.9
Tighten, with the provided Hex Wrench (HEX-332), the longer Set
Screws into the Stop Collars so that a Set Screw rests against
each side of the Pedestal preventing movement of the Table.
Diagram 4-100
Shroud
Hand Wheel
Hand Wheel
Lock Knob
Diagram 4-110
Pedestal
3/32" Hex Wrench
Short Set Screw
Stop Collar Rod
Stop Collar
Diagram 4-120
3/32" Hex Wrench
Long Set Screw
Stop Collar Rod
Stop Collar
Pedestal Pin
Pedestal
Pedestal Pin
Page 11
Advertisement
Table of Contents
