Multi-Hole Set-Up; Traversing The Table - Lassco Spinnit FMM-2 User Manual

4 - Operation

4.8 - Multi-hole Set-Up

4.8.1
If a hole pattern includes more than three (3) holes, you will need to adjust the Stop Collars to the desired spacing.
The Stop Collars are adjusted as descibed in section 4.7. To set the distance between the stop collars, follow steps
4.8.2 through 4.8.5.
4.8.2
Locate the product on the Table and adjust the Paper Side Stops to trap the material allowing no lateral movement.
4.8.3
Move the Table to align zero (0) on the Back-gauge Scale with the center drill bit.
4.8.4
Loosen the Stop Collars and position the first one against the Pedestal Pin marking the beginning position of the
Table and tighten in place.
4.8.5
The right side of this Stop Collar now indicates the center of the product to be drilled. Place the remaining Stop
Collars as desired by measuring with a Ruler (not provided) to the desired positions and tighten them down. Always
measure from the right side of the Stop Collar to the right side of the next Stop Collar as shown.
4.8.6
Due to the width of the Stop Collars, the shortest travel between holes is 3/8". Almost any center-to-center distance
can be drilled, but requires variations of table travel and lateral head adjustments.

4.9 - Traversing the Table

4.9.1
When all the Stop Collars are positioned as desired return the
Table to its original position. When traversing the Table during
drilling (see section 4.10), move the Table to the left until the Ped-
estal Pin "clicks" over the next Stop Collar. Pull the table back
to the right and hold it there to assure contact between the Stop
Collar and the Pedestal Pin. Refer to diagram 4-140. Continue
drilling and repeat as needed.
4.9.2
To reverse the direction of the Table traverse, lift up on the Ped-
estal Pin Knob and turn it around. This will cause the angle of the
Pedestal Pin to reverse allowing the Table to travel back over the
Stop Collars. There are Locking Pins on the Pedestal Pin that fit
into a groove on the Pedestal keeping it locked into a
direction. Refer to diagram 4-150.
Diagram 4-130
Ruler (not provided)
Diagram 4-140
Pedestal Pin
Table
Diagram 4-150
Pedestal Pin Knob
Locking Pins
Pedestal
Page 12