Maintenance; Safety; Annual Lubrication - Lassco Spinnit FMM-2 User Manual

5 - Maintenance

5.1 - Safety

ALWAYS DISCONNECT THE POWER BEFORE PERFORMING MAINTENANCE
ON THIS MACHINE. MAINTENANCE SHOULD ONLY BE PERFORMED BY A
QUALIFIED TECHNICIAN.
KEEP HANDS CLEAR WHILE PERFORMING MAINTENANCE ON THIS MACHINE.
MOVING PARTS CAN CRUSH AND CUT.

5.2 - Annual Lubrication

5.2.1
Lubricating your FMM-2 should be done at least once every 12
months; however, it may be necessary to lubricate certain parts
more often depending on use. Whenever a moveable or adjust-
able part starts becoming difficult to move or adjust, it may be time
to lubricate.
5.2.2
Remove the Table by loosening the left end Stop Collar on the
Stop Bar Assembly and rotating the Table Traverse Stop down to
clear the Pedestal. Pull the Table to the right until the Table clears
the slide beneath the Table. Inspect the slide for build-up and
lubricate with light machine oil. Using the Foot Treadle raise the
Slide and Lubricate the bars underneath the Slide as shown. Re-
place the Table in the same manner as it was removed and check
the Table traverse for free travel. Refer to diagram 5-10.
5.2.3
Lubricate the Stop Pin with light machine oil, work the pin up and
down and rotate it a few times for proper lubrication. Refer to
diagram 5-20.
5.2.4
Lubricate the pivot points, shown in the diagram 5-30, in the lower
back portion of the machine with light machine oil. Lubricate the
Treadle Pivot Assembly at the front of the machine in the same
manner.
Table Assembly
Lubricate
Lubricate
Lubricate
Lubricate
Diagram 5-10
Diagram 5-20
Lubricate
Pedestal
Diagram 5-30
Lubricate
Slide
Page 14