Lassco Spinnit FMM-2 User Manual page 16

5 - Maintenance
5.2 - Annual Lubrication
5.2.5
Press down on the Foot Treadle to Raise the Table. Manually
holding the Table in place, slowly let up on the Foot Treadle so
that the Push Rods in the rear of the machine fall out of the Pin
Housings.
5.2.6
Lubricate the tips of the Push Rods and while holding up the Table
return the Push Rods into the Pin Housings. Release the Table so
that the Push Rods are locked in place.
5.2.7
Push down on the Foot Treadle to check for freedom of Travel.
5.2.8
Making sure the machine is unplugged and after disconnecting the
electrical wiring to the Switch on the shroud, remove the shroud
by lifting straight up to clear the drive mechanism making sure the
Traverse Locks are disengaged.
5.2.9
Lubricate the two (2) Idler Pulleys with a good grade of grease. A
grease gun is required (not included). Rotate the belts by hand
to check the Idler Pulleys for wear. Some play between the Idler
Pulley Bearings and the Idler Pins comply with original specifica-
tions and is not a problem. Refer to diagram 5-50.
5.2.10 Lubricate the Head Traverse Screws by applying light grease ei-
ther by hand, or a small brush to the points indicated in diagram
5-60. Move the heads to both extremes to coat the complete
surface of the screws and inspect them for thread wear.
Diagram 5-40
Push Rods
Rear View
Diagram 5-50
Grease Points
Belt
Diagram 5-60
Grease
Grease
Lubricate
Belt
Grease
Grease
Page 15