Table of Contents
Advertisement
3 - Setting Up Your Machine
3.3 - Uncrating and Removing From the Pallet
3.3.1
Remove the wooden framing around the outside box.
3.3.2
Remove the box up and over the machine.
3.3.3
Remove the two (2) 5/16" bolts which are securing the machine to
the pallet: access through the rear of the machine using a 5/16"
wrench (not provided) as shown in diagram 3-10. Discard the two
(2) 5/16" bolts.
3.3.4
Remove the FMM-2 from the pallet carefully "stepping" it off the
edge. DO NOT drop the machine. DO NOT lift by the table. Two
people may be needed to remove the machine from the pallet
safely.
3.4 - Installing the Leveling Feet
3.4.1
Set the machine down in its desired location and determine if the
machine is level, making sure that it does NOT rock in any direc-
tion. If it does, determine which Leveling Feet need to be adjusted
and whether they need to be adjusted up or down.
3.4.2
If adjustment is needed, start by loosening the four (4) nuts which
are accessed through the rear of the machine.
3.4.3
Next adjust the four (4) Leveling Feet by screwing them clockwise
to raise the or counter-clockwise to lower. After each adjustment
set the machine down completely to verify that the machine no
longer rocks. Continue adjustment as needed until the machine
sits securely in place. Tighten the four (4) nuts down to secure the
position of the Leveling Feet.
FMM-3
5/16" Bolts
Wooden Pallet
Leveling Feet
Diagram 3-10
Diagram 3-20
Base of the Machine
Nut
Page 06
Advertisement
Table of Contents
