Omron ZS-MDC User Manual page 29

■ Installing on the DIN track
The following describes how to attach the 35 mm wide DIN track by quick, easy opera-
tion.
●
Installation procedure
The following describes how to install the Multi-Controller and Sensor Controller on the
DIN track.
1.
Hook the connector end of the Sensor
Controller onto the DIN track.
2.
Push the Multi-Controller down onto the
DIN track until the hook on the I/O cable
side is locked.
Push down until you hear it snap into
place.
Always hook the connector end of the Multi-Controller on the DIN track first. Hooking the I/O cable
end on the DIN track first may impair the mounting strength of the DIN track attachment.
Section 2
Multi-Controller
DIN track (sold sepa-
rately)
PFP-100N (1 m)
PFP-50N (0.5 m)
PFP-100N2 (1 m)
End plate (sold separately)
PFP-M
Hook on connector
Hook on I/O cable
ZS-MDC
User's Manual
2-5