Direct Connection Bar Graphs - Omron NT-series Operation Manual

Bar Graphs
(Number of display dots) = (Maximum length of graph) x
Setting % Display Position
Deleting and Modifying
2-6-2

Direct Connection Bar Graphs

Creating
1, 2, 3... 1.
Displaying –60%
Without sign
With sign
3. The following relationship exists between the number of display dots on
the screen, the content of the numeral table reference, and the 100% val-
ue.
If the results for a bar graph display is over 100%, a 1-dot blank will be
displayed past the size set with the Support Tool and an 8-dot bar will be
display beyond the blank to indicate a value over 100% (see below).
If the % Display is set to "Yes," then the display position is designated. If it is
set to "No," then this screen is not displayed.
Designate the display position of the percentage value.
You can delete or modify previously input bar graph data on the screen. The
procedures for these operations are the same as those for deleting and mo-
difying character strings. Refer to appropriate subsections of 2-1 Inputting
Character Strings for details.
Use the following procedure to create a direct connection bar graph.
Select BAR GRPH from the Initial Edit Display, a list of the bar graphs
already existing in the current screen will be displayed.
The headings in this list are as follows:
No.: The number of the bar graph in the current display.
(Referenced numeral table)
(100% data value)
1 dot
8 dots
Section 2-6
0%
–60%
55