Omron NT-series Operation Manual page 60

Bar Graphs
56
This is not the numeral table entry number.
M Tbl: The numeral table entry number being used.
Rf: The access method for the numeral table (direct or indirect)
Dr: The direction of the bar.
%: Whether or not the percentage display is being used.
2. Specify the number to be used in the table. This is not the numeral table
and the numbers do not correspond to item numbers in the numeral
table. When the number is specified, a cursor will appear to designate
the starting and ending points of the bar.
3. Designate the starting and ending points of a diagonal line across the
bar graph. It makes no difference whether the display position of a bar
graph is designated from the right or left, or from the top or bottom. The
ending point designates only the length (along the X axis) of the bar
graph. Whether the bar is vertical or horizontal is designated later in the
display settings. When the length is designated, a display to set direct or
indirect referencing will appear.
4. Specify "Direct." Indirect referencing is not currently supported. The nu-
meral table will be displayed.
5. Specify the desired table entry number. The initial value input field (con-
tents) will be entered. The headings in the table are described in the
following table.
Heading
No.
Contents
IN (initialize at startup)
# (quantity)
Word
Comment
6. Input the desired initial value. This value can be omitted here if desired
and input later using the table edit operation. The initial value can be up
to 8 digits long. When the initial value field is left, the following display
will appear to input the remaining settings.
Meaning
Numeral table entry number
Initial value
Indicates whether or not the table value is to be
initialized when the PT is turned ON.
Number of PC words used
Address of the first PC word
User comment area
Section 2-6