Adjusting The Cut-Off Bar - Toro 04018 Greensmaster Flex 18 Operator's Manual

4. Rotate adjusting screw until roller contacts front of
gauge bar. Adjust both ends of roller until entire
roller is parallel to the bedknife.
Important: When set properly, the rear and
front rollers will contact the gauge bar and the
screw will be snug against the bedknife. This
ensures that the height-of-cut is identical at both
ends of the bedknife.
5. Tighten nuts to secure adjustment. Do not
overtighten nut. Tighten enough to remove play
from washer.
Note: Use the following chart to determine which
bedknife is best suited for the desired height of cut.

Adjusting the Cut-Off Bar

Adjust cut-off bar to assure clippings are cleanly
discharged from the reel area:
1. Loosen screws securing top bar (Figure 58) to
cutting unit.
Figure 57
1. Cut-off bar
2. Insert .060 inch feeler gauge between top of reel and
bar and tighten screws. Ensure bar and reel are equal
distance apart across complete reel.
Note: The bar is adjustable to compensate for
changes in turf conditions. The bar should be
adjusted closer to reel when turf is extremely dry.
By contrast, adjust bar further away from reel when
turf conditions are wet. The bar should be parallel to
reel to ensure optimum performance and should be
adjusted whenever reel is sharpened on a reel grinder.
34
Figure 58