Servicing The Bedbar - Toro 04018 Greensmaster Flex 18 Operator's Manual

Use the following table and Figure 59 to set the rate of
clip.
Clip (Refer to Figure 59 for pulley locations.)
Drive pulley number of teeth
27
22
22
The reel is shipped with one 27 tooth and one 22 tooth
pulley. To get a .16 inch clip, you must purchase a 22
tooth pulley. The clip can only be changed on the reel
drive (Figure 59). Do not change the drive ratio on the
gearbox pulleys.
1. Reel drive belt
2. Drive pulley

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar adjuster screw, counterclockwise, to
back the bedknife away from reel (Figure 60).
1. Bedbar adjusting screw
2. Spring tension nut
3. Bedbar
Driven pulley number of teeth 11 Blade Clip
22
22
27
Figure 59
3. Driven pulley
Figure 60
4. Jam nut
5. Bedbar bolt
.14 inches (standard)
.16 inches
.21 inches
2. Back out the spring tension nut, until the washer is
no longer tensioned against the bedbar (Figure 61).
3. On each side of the machine, loosen the jam nut
securing the bedbar bolt (Figure 61).
1. Bedbar bolt
4. Remove each bedbar bolt allowing bedbar to be
pulled downward and removed from machine.
Account for 2 nylon and 2 stamped steel washers on
each end of bedbar (Figure 62).
1. Bedbar bolt
2. Steel washer
Assembling the Bedbar
1. Install bedbar, positioning mounting ears between
washer and bedbar adjuster.
36
8 Blade Clip
.19 inches
.24 inches
.29 inches
Figure 61
2. Nut
Figure 62
3. Nut
4. Nylon washer