Map-Select Switch For The Basic Setting (Sx-F Factory Edition); Map-Select Switch For Vehicle Operation (Sx-F Factory Edition); Overview Of Indicator Lamps; Opening The Filler Cap - KTM 450 SX-F Owner's Manual

6 CONTROLS
6.6 Map‑Select switch for the basic setting (SX‑F Factory Edition)
6.7 Map‑Select switch for vehicle operation (SX‑F Factory Edition)
6.8

Overview of indicator lamps

6.9

Opening the filler cap

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Store fuel properly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
The Map‑Select switch for the basic setting
Possible states
1
2
3 - 9, 0
101958-10
The Map‑Select switch for the basic setting is used to make a preselection of the
engine characteristics.
The Map‑Select switch for vehicle operation
bar.
Possible states
The Map‑Select switch for vehicle operation is used to change the engine characteris-
101957-10
tics on the handlebar. This change is activated when the engine is idling or after the
motorcycle is restarted.
Possible states
(XC‑F)
C00394-10
SOFT – The mapping with reduced peak performance for better ride-
ability is activated.
ADVANCED – The mapping for performance with a very direct response
is activated.
STANDARD – The mapping for performance with a balanced response
is activated.
STANDARD – STANDARD mapping is always activated in this setting.
SOFT or ADVANCED – The mapping that is set on
the Map‑Select switch for the basic setting is activated in this setting.
FI warning lamp (MIL) lights up/flashes orange – The OBD (on-board
diagnosis) has detected an emission- or safety-critical error.
The fuel level warning lamp lights up orange – The fuel level has
reached the reserve mark.
1
is fitted under the seat.
1
is fitted on the right side of the handle-
12