13
WHEELS, TIRES
13.4
Installing the rear wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Remove spacers
S00173-10
x
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
S00173-11
–
Position the rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Put the chain on.
C00448-10
–
Position chain adjuster
–
Make sure that chain adjusters
–
Check the chain tension. (
–
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm (1.18 in))
enables different secondary ratios with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
C00449-01
Finishing work
–
Remove the motorcycle from the lift stand. (
4
.
x
1
p. 102)
3
. Mount nut
3
are fitted correctly on adjusting screws
p. 54)
4
.
3
can be turned by 180°.
A
and contact surface
of the spacers.
2
.
4
, but do not tighten it yet.
M25x1.5
80 Nm (59 lbf ft)
p. 36)
71
5
.