Table of Contents
Advertisement
Setup
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Note:
R For information about deregistering
devices, refer to the User's Guide
(page 17).
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
Sensor:
Press and hold M
LED indicator blinks slowly in
green (page 8).
R When registration is complete,
Note:
R To cancel without registering the
sensor, press M
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
10
HNS104_(en_en)_1102_ver.310.pdf
OTHER
N until the
the hub sounds one long beep.
N on the hub and
For assistance, please visit http://shop.panasonic.com/support
10
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign a name to your devices and
group them by location. For more
information, refer to the User's Guide
(page 17).
2015/11/02
14:58:48
Advertisement
Chapters
Table of Contents
