Information About Sensor Features - Panasonic KX-HNS104 Installation Manual

Setup
Information about
sensor features
The sensor uses a microphone to
detect the unique sound frequencies
that are produced when glass breaks.
Please read the following information
before deciding where to install the
sensor.
Note:
R The sensor's features are not
designed to be used in situations
that require high reliability. We do
not recommend use of the sensor's
features in these situations.
R Panasonic takes no responsibility for
any injury or damage caused by the
use of the sensor.
R The sensor may make false
detections when there is noise from
metallic blinds opening and closing,
metallic bells of alarm clocks, etc.
R The sensor is designed to detect the
sound of glass breaking as a result
of an impact. It will not detect other
types of breaks, such as when glass
is cut or removed.
R If the sensor malfunctions, is out of
range, or if its battery power is too
low, the hub sounds an alert, the
hub's indicator flashes, and a
message is displayed by the [Home
Network] app. You can cancel the
alert temporarily by pressing the
hub's MWi-Fi SETUPN button. When
you have remedied the situation
(e.g., moved the sensor closer to the
hub, replaced the battery, etc.), the
alert will not sound again.
12
HNS104_(en_en)_1102_ver.310.pdf
For assistance, please visit http://shop.panasonic.com/support
12
Applicable glass
specifications
*1
Type Thickness
Plate Minimum: 2 mm
(1/16 inch)
Maximum: 6 mm
(1/4 inch)
Tempered Minimum: 3 mm
(1/8 inch)
Maximum: 6 mm
(1/4 inch)
Minimum: 2 mm
Insulating *2
(1/16 inch)
Maximum: 6 mm
(1/4 inch)
*1 In compliance with UL 639.
*2 Sealed insulating glass types are
protected only if both plates of
glass are broken.
Note:
R Minimum size for all types is 28 cm
´ 28 cm (11 1/32 inches ´ 11 1/32
inches).
R The glass must be secured in a
frame, and the frame must be
installed in a wall.
R The sensor may not detect glass
breaks for types of glass not listed
here, such as wire-mesh reinforced
glass and glass coated with a film.
R Install the sensor in accordance with
the Standard for Installation and
Classification of Burglar and Holdup
Alarm Systems, UL 681.
2015/11/02 14:58:48