Table of Contents
Advertisement
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Servicing the Fuses
The fuses in the electrical system are located under the seat
(Figure
53).
Figure 53
1. Fuses
Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction control pedal is in
the N
position, adjust the neutral-return mechanism.
EUTRAL
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: If machine is equipped with a 3-Wheel Drive
Kit, raise and block the rear wheel.
2. Start the engine, move the throttle to the S
position, and ensure that the front wheel that is off
of the floor is not rotating.
3. If the wheel is rotating, shut off the engine and proceed
as follows:
A. Loosen both jam nuts securing the traction-control
cable to the bulkhead on the hydrostat
54). Ensure that the jam nuts are loosened equally
and sufficiently to allow adjustment.
1. Traction cable
2. Bulkhead
3. Jam nuts
Note: Loosen the nut securing the eccentric to
the top of the hydrostat
B. Move the functional-control lever to the N
position and the throttle lever to the S
position.
C. Start the engine.
D. Rotate the eccentric until creep does not occur
in either direction.
E. When the wheel stops rotating, tighten the nut
locking the eccentric and the adjustment
54).
39
LOW
Figure 54
4. Eccentric
5. Locknut
(Figure
54).
LOW
(Figure
EUTRAL
(Figure
Advertisement
Table of Contents
