Adjusting The Throttle Lever; Adjusting The Choke Control - Toro Greensmaster 3150 04358 Operator's Manual

2. Remove the oil filter
3. Apply a light coat of clean oil to the new filter gasket.
4. Screw the filter on by hand until the gasket contacts the
filter adapter, then tighten it 3/4 to 1 turn further. Do
not overtighten it.
5. Add oil to the crankcase; refer to
Oil (page 21).
6. Dispose of the oil filter and used oil properly.
(Figure 48).
Checking the Engine

Adjusting the Throttle Lever

Proper throttle operation is dependent upon proper
adjustment of the throttle lever. Before adjusting the
carburetor, ensure that the throttle lever is operating properly.
1. Loosen the cable-clamp screw securing the cable to the
engine (Figure 49).
1. Throttle-cable-clamp
screw
2. Throttle cable
3. Swivel
4. Stop
2. Move the throttle lever forward to the F
3. Pull firmly on the throttle cable until the back of the
swivel contacts the stop
4. Tighten the cable-clamp screw and check the engine
rpm setting.
•
High Idle: 2800 to 2900 rpm
•
Low Idle: 1550 to 1750 rpm

Adjusting the Choke Control

1. Loosen the cable-clamp screw securing the cable to the
engine (Figure 49).
2. Move the choke lever forward to the C
3. Pull firmly on the choke cable until the choke butterfly
is completely closed, then tighten the cable-clamp
screw (Figure 49).
36
Figure 49
5. Choke-cable-clamp screw
6. Choke cable
7. Choke butterfly
AST
(Figure 49).
LOSED
position.
position.