Table of Contents
Advertisement
Seat-Adjustment Lever
This lever, on the left side of the seat
cm (4 inch) forward and rearward adjustment of the seat.
Figure 14
1. Seat-adjustment lever
Raise/Lower Mow Control
Moving the control
(Figure
lowers the cutting units and starts the reels. Pull back the
control to stop the reels and raise the cutting units. During
operation pull back on the control momentarily and release it,
if you need to stop the reels; start the reels again by moving
the control forward.
Figure 15
1. Functional-control lever
2. Ignition switch
Functional-Control Lever
The functional-control lever
selections plus a N
EUTRAL
to transport or transport to mow (not to neutral) while the
machine is in motion; no damage will result.
•
R
position—neutral and backlapping
EAR
•
M
position—used for mowing operation
IDDLE
•
F
position—used for transport operation
RONT
(Figure
14), allows a 10
15) forward during operation
3. Raise/lower mow control
(Figure
15) provides two traction
position. You can shift from mow
Ignition Switch
Insert the key into the ignition switch
clockwise as far as possible to the S
engine. Release the key as soon as the engine starts; the key
will move to the O
position. Turn the key counterclockwise
N
to the O
position to stop the engine.
FF
Steering-Wheel Locking Lever
Rotate the lever
(Figure
raise or lower steering wheel for operator comfort, then,
rotate the lever rearward to tighten the adjustment.
1. Steering-wheel locking lever
Steering-Arm Locking Knob
Loosen the knob
(Figure
clears the notches in the steering arm. Raise or lower the
steering arm to the desired height while aligning the shoulder
of the knob with the notch in the steering arm. Tighten the
knob to lock the adjustment.
1. Steering-arm locking knob
19
(Figure
15) and turn it
position to start the
TART
16) forward to loosen the adjustment,
Figure 16
17) until the shoulder on the knob
Figure 17
Advertisement
Table of Contents
