Table of Contents
Advertisement
•
Lift cylinders (3)
(Figure
•
Traction pedal
(Figure
•
Speed-selector linkage
42)
Figure 42
43)
Figure 43
(Figure 44
and
Figure
45)
Figure 44
To grease the machine, complete the following procedure:
1. Wipe the grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing until the
grease is visible. Wipe up excess grease.
3. Apply grease to the reel motor spline shaft and onto the
lift arm when the cutting unit is removed for service.
4. Apply a few drops of SAE 30 engine oil or spray
lubricant (WD 40) to all pivot points daily after
cleaning.
34
G017145
Figure 45
Advertisement
Table of Contents
