Table of Contents
Advertisement
3
Installing the
Rollover-Protection System
(ROPS)
Parts needed for this procedure:
2
Bolt (1/2 x 1.75 inches)
6
Bolt (1/2 x 1.5 inches)
1
Washer
8
Nut (1/2 inch)
Procedure
1. Remove the screws, nuts, and washer supporting the
jack pad on the right side of the machine.
2. Lower the roll bar
brackets, aligning the mounting holes.
3. Secure the left side of the roll bar to the mounting
bracket with 4 bolts (1/2 x 1.5 inch) and locknuts
(Figure
6).
Note: Torque the fasteners to 91 to 115 N∙m (67 to
85 ft-lb).
4. Secure the right side of the roll bar and the previously
removed jack pad to the mounting bracket with 2 bolts
(1/2 x 1.5 inches), 2 bolts (1/2 x 1.75 inches), 1 washer,
and locknuts as illustrated in
Important: Ensure that you install the washer in
the correct location as illustrated in
Note: Torque the fasteners to 91 to 115 N∙m (67 to
85 ft-lb).
WARNING
Failure to wear the seat belt while operating the
vehicle can result in you being thrown from the seat
and crushed during a rollover accident.
Always use the seat belt.
(Figure
6) onto the mounting
Figure
6.
Figure
1. Jack pad
2. Bolt (1/2 x 1.75 inch)
3. Bolt (1/2 x 1.5 inch)
4
Installing the Cutting Units
For Models 04610, 04611, 04616, 04618,
04619, 04624, 04652, 04654, and 04656
Parts needed for this procedure:
6.
1
Bolt (#10 x 5/8 inch)
1
Jam nut (#10)
3
Cutting unit
3
Grass basket
Procedure
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders on the
machine frame. Damage to the motors or hoses could
result.
Note: When sharpening, setting the height of cut or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
on the front of the frame and side of the machine to prevent
damaging the hoses.
15
Figure 6
4. Washer
5. Roll bar
6. Seat belt
Advertisement
Table of Contents
