Sound Adjustment - Technics SU-G30 Operating Instructions Manual

Settings
Sound adjustment, Other settings
Update via Internet
■
Preparation
• Connect this unit to the network. ( 18)
- Make sure that the network is connected to
the Internet.
1 Press [SETUP].
2 Press [ ], [ ] repeatedly to select
"F/W Update" and then press [OK].
3 Press [ ], [ ] to select "Internet" and
then press [OK].
4 Press [ ], [ ] to select "Yes" and then
press [OK].
• The progress is displayed as "Updating
while updating. (
• When the update has finished successfully,
"Success" is displayed.
5 Disconnect the AC mains lead and
reconnect it after 3 minutes.
Note
• Downloading may take longer or may not
work properly depending on the connection
environment.
Update via USB flash memory
■
Preparation
• Download the latest firmware on the USB flash
memory. For details, refer to the following
website.
www.technics.com/support/firmware/
1 Connect the USB flash memory with
new firmware.
2 Press [SETUP].
3 Press [ ], [ ] repeatedly to select
"F/W Update" and then press [OK].
4 Press [ ], [ ] to select "USB" and then
press [OK].
5 Press [ ], [ ] to select "Yes" and then
press [OK].
• The progress is displayed as "Updating
while updating. (
• When the update has finished successfully,
"Success" is displayed.
6 Disconnect the AC mains lead and
reconnect it after 3 minutes.
40
%"
stands for a number.)
%"
stands for a number.)
(Continued)
Note
• Downloading may take longer depending on
the USB flash memory.

Sound adjustment

The following sound effects can be added to the
audio output.
Listening to more natural-sounding audio
(Re-master)
Re-mastering expands the playback band and
achieves a higher bit depth to reproduce natural
and expansive sound close to original music.
• The factory default is "Off".
Press [RE-MASTER] to select "On"/"Off".
Direct mode
When this mode is set to on, the audio signal
is output directly without performing various
processing circuits.
• The factory default is "Off".
Press [DIRECT] to select "On"/"Off".