Connections; Speaker Connection - Technics SU-G30 Operating Instructions Manual

Connections

Speakers/AC mains lead
• Use only the supplied AC mains lead.
• Do not connect the AC mains lead until all other connections are complete.
• Insert the plugs of the cables to be connected all the way in.
• Do not bend cables at sharp angles.
• To optimise the audio output, you can measure the amplifier output signal and correct its
output when it is connected to the speakers. ( 41)

Speaker connection

1 Turn the knobs to loosen them, and
insert the core wires into the holes.
2 Tighten the knobs.
16
PHONO LINE IN
PHONO
EARTH
Speaker cable (not supplied)
Note
• When the connections are completed, pull the
speaker cables lightly to check that they are
connected firmly.
• Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so
may damage the amplifier.
DO NOT
• Wire the polarity (+/-) of the terminals correctly.
Not doing so may adversely affect stereo
effects or cause malfunction.
• For details, refer to the operating instructions of
the speakers.
LAN
OPT COAX1 COAX2 PC
10BASE-T /
DIGITAL IN 100BASE-TX
SPEA
(4∼1 1